Silicone rubber is a highly elastic material with a long service life because it can be used in a variety of harsh environments. We use high quality materials to supply silicone rubber sealing rings and silicone rubber sealing strips, which are commonly used for gaskets, seals, heat insulation panels, MATS and insulation applications.

Silicone rubber ring provides advantages:

1, performance in a wide temperature range

2. Good tensile strength

3. Flexibility

4. Compression deformation resistance

5. Excellent electrical insulation in nature

6. Good resistance to harsh environments such as uv, moisture, ozone and pollutants

Silica gel products are used in many fields, because of its own characteristics, make it popular with users, but some people find that its appearance will appear bad, which requires us to understand the specific repair work, to avoid certain problems, so we must pay attention to.

1. Poor product numbness. Silicone rubber seal ring manufacturers introduced the causes of poor numbness of silicone products, mainly by controlling the mold temperature and exhaust to achieve repair. The product has poor stains. For the surface of silica gel products, the method of cleaning stains is: first look at the surface stains. If the stains on the surface are very light and small, then use fine sandpaper to gently polish; If the stain is deep or large, remove the stain with a razor blade.

2. Poor product quality. Pick some silicone products that are not ripe or can't press the white spots. Die temperature caused by the local unripe can be unripe rubber material press close wipe flat, and then put into the mold pressure vulcanization, as for exhaust improper white point first by hand, usually can press out, but do not drop on the mold pressure vulcanization.

3. Defective dark marks. The silicone rubber seal ring manufacturer introduced that there is no repair method for the poor dark mark of silicone products, so the dark mark can only be avoided. Product lack of rubber material bad, can only choose a slight lack of material, in the lack of rubber to fill the point of raw rubber, must not be too much, just uneven or can be a little less, with the blade to fill the raw rubber smooth, and then put into the molding mold pressure vulcanization. Note that the pressurized repair must be the lifting mode of the machine, the track type machine in the mold when the machine will crush the product bias.